Gateway = Select the Wireguard interface that was just created.Make sure that the Mikrotik router has routes to support the reverse traffic coming from Perimeter81.After you click "Apply" and "Okay" you should see RX and TX indicating your tunnel is up.Endpoint IP = Your Perimeter81 gateway IP.Make sure your settings mirror the following:.Select the Peers Tab and then "Add New".The public key is generated automatically.Configure the interface like the following:.Select the Wireguard tab, then add a new Wireguard connection.This will contain all of the information you'll need to establish a Wireguard tunnel with Perimeter81 using your Mikrotik router.Ĭonfiguring your Wireguard tunnel in your Microtik firewall Take note of all lines that begin with CONFIG_.Open that file with your favorite editor (Sublime, Notepad, etc.) This will immediately be followed by a file download. Copy just the URL (starting with and ending but including the | ).Start by creating a P81 Connector Tunnel in the Perimeter 81 portal on your gateway.Please follow the steps below: Configuring the Wireguard tunnel in Perimeter81 In order to be able to add a Wireguard connector, you will need to be on version 7.0 or later of the RouterOS firmware.
0 kommentar(er)
